Line Streets, Sidewalks, And Beyond

To install brick pavers over concrete, lay a "soldier course" line of bricks perpendicular to the edge of the concrete to form the outside frame of the project.

To install brick pavers over concrete, lay a “soldier course” line of bricks perpendicular to the edge of the concrete to form the outside frame of the project.

pavers in place, leaving a joint at least 1/16-inch wide between. Then, install edge restraints, which can be metal or plastic, or even stand a row of finished pavers on end or use troweled concrete. Tamp or compact the pavers into the sand bed. Always use a cushioning device to avoid chippage. A neoprene mat may be available for the compactor, or use a piece of scrap plywood or carpet on top of the pavers. After that, sweep sand into the joints. 

Permeable-Paver Installation

A permeable-paver system is somewhat similar, except that special open-graded aggregates without fine particles are used instead of crusher run and sand. In addition, special permeable pavers with larger nibs—spacers that keep the pavers apart and allow water to seep between them—are required. 

Figuring the depth of the underlayment is also different. The standard is to dig down 12 inches, but some installations, as in streets, are much deeper. Since the idea is to trap stormwater and then release it slowly into the ground underneath, the depth depends on how much water needs to be handled, which is a question for an engineer.

Use #2 stone as a sub-base, followed by a finer grade of #57 stone. The bedding layer, just beneath the pavers, is #8 or #89 aggregate, which is also swept into the joints. Every 4 inches, roll or compact the aggregate into place. The series of aggregates allow water to flow as bacteria builds around the rock over time and aids in reducing pollutants. 

The installation may be challenging, but the rewards are two-fold. Permeable pavers allow builders to potentially qualify for LEED credits in four ways, including stormwater design, heat island effect (non-roof), use of recycled content, and use of regional materials. In addition, when the cost of maintenance is included, permeable pavers may actually cost less than asphalt. 

Existing Concrete Installation

To install brick pavers over concrete, start by choosing the type of clay paver and a pattern. Some pavers—1 3/8-inch thick—are especially made for this purpose. 

To begin, lay a “soldier course,” a line of bricks perpendicular to the edge of the concrete to form the outside frame of the project. The secret is to use four or five dots of masonry adhesive on each brick, each about the size of a penny, which allows rainwater to pass underneath. 

It helps to set two borders first, lay the pavers, and then set the remaining two. It also helps to measure the pavers in the pattern first as the edge course can be adjusted slightly over the edge of the concrete in order to limit cuts to half pavers or eliminate cuts altogether. 

On the inside of the soldier course, cut pieces of roofing felt to put a single layer inside the frame covering the concrete, and don’t overlap the felt edges. Then lay a second layer of felt perpendicularly over the top of the first layer.

Starting at one corner, begin laying the brick in place, leaving a 1/8-inch gap between the pavers. Finish by sweeping concrete sand between the joints until they are full. 

Learning More

There may be a construction program at a trade school nearby, or you can take advantage of apprenticeship programs offered by trade associations. Examples include the School For Advanced Segmental Training (www.paverschool.com) and the Interlocking Concrete Pavement Institute. Training is also offered at the Hardscape North America trade show (www.hardscapena.com). 

Ted Corvey is a recognized national authority on clay brick pavers and their installation. Corvey is the vice president of sales and marketing at Pine Hall Brick Company, a manufacturer of clay brick pavers. For more information, visit www.pinehallbrick.com or call (800) 334-8689.

Page 2 of 2 | Previous page

Related posts:

  1. Makeover On A Budget
  2. Building With Pavers, Stone, And Brick
  3. Choosing Patio Flooring
  4. Pine Hall Brick Wins Gold
  5. Retrofitting For Sustainability

Leave a Reply

Your email address will not be published. Required fields are marked *

*

HTML tags are not allowed.

  • Columns
  • Departments